12 Volt Power Strip Project page 3
Alright! Here is the upside down shot. I've mounted the final washers and nuts and tightened things
down. I've just put on the rubber feet too! I had to double up on them because the nut was about
the same height as a single one.
Yes!!! Finally it's done! Yipee! It turned out (almost)
exactly as I pictured it would!
When I started this project I was starting my first day off (I work
nights) on a week of vacation
so I was staying up as long as I could to switch over to 'day shift'.
When I finally finished
this project I'd been up for 34 hours! Ouch! I was just
enjoying myself so much I wouldn't
go to bed! hehehehe :)
...and the last two shots here are me hooking it up to the 12 Volt
25 Amp power supply
and doing some voltage tests! (My meter won't do current that
high!)
Looks good! Showoing about 13.8 or 13.9 on the analog meter and
13.69 on the Digital!
It's supposed to be 13.8 so things are looking pretty good!
Yipee! Another fun project is done!